|
|
(AMERICAN COMPANIES) : ROLLS
Prices may have changed on the official site. | Next page >> [ 1 ] 
Musiciansfriend | Rolls MP13 Mini-Mic Preamp | | 
Musiciansfriend | Heil Sound PR 35 Dynamic MicrophoneThe Heil Sound PR 35 is an incredibly versatile vocal mic. It has an amazing amount of rear rejection but exhibits no off-axis coloration, so it is like having a supercardioid and omni mic in one! It works well for commercial broadcast, recording, and live sound reinforcement applications. When you need a smooth, flat response over a wide frequency range the Heil PR 35 is your mic. The PR 35 was designed around the acclaimed PR 30 element and incorporates a sorbothane shock mount to give you the best possible results.The PR 35 mic achieves its exceptional performance by using a special magnet structure and a large aluminum 1-1/2" low-mass voice coil assembly. A carefully wound and placed hum bucking coil allows the Heil PR 35 to be placed near video monitors without unwanted hum or buzz. Special attention has been paid to the phasing plug assembly with equally placed ports that sense audio from behind the source. It then enters them out of phase, thus producing a very linear cardioid pattern. This reduces the proximity effect while achieving the extreme articulation across its smooth 40 Hz - 18 kHz frequency response. The Heil element can be used in extreme high sound pressure levels and is immune to overload conditions. It produces a beautifully smooth audio response without the inconvenience of phantom or outside DC powering.The PR 35 microphone is equipped with a three-position roll-off switch. The first position is flat, the second position rolls off at approximately -3 dB and the last position rolls off at approximately -6 dB.The Heil PR 35 mic's cardioid pattern offers the greatest rejection of unwanted audio at 180° off axis, which is directly behind the microphone; there is virtually no off-axis coloration.Supplied with a microphone clip that mounts to any 5/8" 27-thread mic stand. It also comes with an aluminum carrying case.For amateur radio, a CC-1 XLR cable is required to interface with a transceiver. $249.00 - See more - Buy onlineIn stockSee larger image | | 
Musiciansfriend | D.W. Fearn VT-3 Dual Channel Vacuum Tube DIThe VT-3 is a dual-channel, all-triode vacuum tube DI ("direct box") for recording electric or electronic instruments. The inputs are designed to provide the proper load impedance for all instruments that have a 1/4-inch phone jack output. Tube circuitry provides the very high impedance necessary to capture all the details of these instruments.The outputs of the VT-3 are mic level (150 ohm source impedance at a nominal -30dBV). The VT-3 is designed to operate into a high-quality microphone preamplifier like the Fearn VT-1 and VT-2 Vacuum Tube Microphone Preamplifiers.Operation is very simple: plug the instrument into the 1/4" front panel jack and take the output either from the front panel XLR connector, or a parallel XLR connector on the back panel. A second 1/4" jack provides an output to feed a guitar amplifier when necessary. A ground-lift switch helps eliminate ground loop buzz, and a switchable high-pass filter gently rolls off frequencies below 100Hz when required.The two channels are entirely independent and can be used with two different instruments at the same time. $2100.00 - See more - Buy onlineOn orderSee larger image
Download manual (PDF) | |
|
|
 (EUROPEAN COMPANY) : ROLLS | NO RESULT
|
|
|
Version française 
